Cold roll forming machine manufacturers introduce the preparations before starting the cold bending machine.
Feb 06,2022
Cold rolling forming machine manufacturer, below is an introduction to the preparation before starting the cold bending forming machine.
Cold rolling forming machine manufacturer: What needs attention before starting the cold bending forming machine?
After all, what should be paid attention to before starting the cold bending machine? Is the cold bending machine unfamiliar to us, and is it the same as the cold bending machine? All these questions are related to the cold bending machine, so we must understand and control it, otherwise we cannot stop understanding this product. Since they are so important, the editor will stop the content explanation below, hoping that everyone can get some help and inspiration from it, and benefit from it.
The inspection before starting the cold bending forming machine mainly includes the following: whether all joints are firm and loose, whether all rotating parts are sensitive and deadlocked, whether the smoothness of the equipment's smooth parts is good, whether the oil level is sufficient, and whether the lubricating oil in each gearbox is above the oil level line.
After the above inspection, start the slip-ring motor to stop the no-load test run, mainly to check for any abnormalities. After the no-load operation, check whether the temperature rise of each rotating part is normal, whether there is any oil leakage, and whether the fasteners can be tightened. If there is a problem, stop cleaning immediately.
Cold bending machine and cold bending machine, although similar in wording, there are differences between the two and should not be confused. Cold bending machine is mainly used for the processing and manufacturing of tunnel support steel arch frames, while cold bending machine can be used directly on the assembly line, so their processing levels are different, and their partial focuses are also different.
Cold rolling forming machine manufacturer: Daily maintenance of air ducts
I believe that most people are no longer unfamiliar with the knowledge of air ducts, but during maintenance, some things may need special attention. Good maintenance habits can improve efficiency and extend the service life of air ducts. The following will focus on several aspects.
Through long-term experience, there are mainly three methods for maintaining air ducts: vacuum suction, gas flushing, and power flushing. Each method has its own advantages and disadvantages.
Vacuum suction loss, the specific operation method is to directly brush the dirt on the inner wall of the pipe, which requires the air duct to have a larger manhole. The disadvantage of this method is that the dust and dirt cannot be completely removed.
Gas flushing, connect a hose with a nozzle to the air duct to deliver compressed air to expel dust from the air duct.
Power cleaning, use pneumatic or electric brushes to brush dust and dirt in the air duct. A requirement for using this method is that the surface of the insulating material cannot be damaged.
The editor of the cold rolling forming machine manufacturer will introduce it here today. Thank you for watching. If you have any other questions, remember to contact our manufacturer. Okay, I wish you a happy life.
Consult Now
Email:
Service Hotline:
Scan code to consult：
Sales Consultation
After-sales Service Consultation
More News
ONLINE CONSULTATION
Please consult if you have any questions, we will answer you as soon as possible! Thank you for your message
Contact Information：
Address: No.49 Jinghu Road, Huadu District, Guangzhou
Sales Consultation
After-sales Service Consultation
