Fully automatic duct production line manufacturers talk about the precautions for ventilation equipment production

　　Fully automatic duct production line manufacturer: Precautions in ventilation equipment production

　　Ventilation equipment does not work independently, but exists and operates as an integral production line system. The entire process, from coil feeding to duct forming, is completed through mechanical processing equipment, and the completion of any part is inseparable from ventilation duct equipment.

　　On-site, economical CNC duct secondary and tertiary production can be selected using cutting equipment. The plates are flattened, pressed, cut, and sheared. Then, the cut plates are processed using multi-functional bite edge machines, ordinary plate bending machines, flanging machines, and seaming machines. After installation, corner codes can be hoisted. During operation, all operations must be completed according to the instructions, and the following matters should be noted.

　　1. Before operation, check whether the data and system of each part of the equipment are intact, and turn on the machine for trial operation. Overloading operation is strictly prohibited.

　　2. The operation of ventilation duct equipment must be completed by professional technicians. More than two people need to cooperate with each other. When the ventilation duct equipment is working, other irrelevant personnel are strictly prohibited from approaching.

　　3. Material selection of equipment parts. In design, manufacturing, and maintenance, appropriate parts produced by Pedu Mechanical Factory should be selected according to the nature and characteristics of the parts' work. Worn, corroded, excessively deformed, fatigued, cracked, and aged products are strictly prohibited for ventilation equipment parts.

　　4. Assembly quality issues. In this case, a reasonable initial clearance needs to be maintained. If the initial clearance is too large, the effective life will be shortened. In addition, the mutual positional accuracy of the components during assembly is also important. If the requirements are not met, it will cause additional stress, uneven wear, etc.

　　5. Conduct appropriate maintenance. According to the principles of reasonable process, cost-effectiveness, and production efficiency, maintenance and maintenance should be carried out reasonably. To ensure maintenance quality, installation, and maintenance, professional personnel must be hired, or experts should be asked for remote guidance. Repair processes should be reasonably selected and used, paying attention to pre-repair preparations, operating according to regulations during repair, and handling post-repair work.

　　Fully automatic duct production line manufacturer: How to safely and correctly operate the flange forming machine

　　1. Operators should be familiar with the equipment performance and operating methods.

　　2. Wear labor protection equipment and fasten cuffs.

　　3. Before operation, carefully check whether the transmission box oil level is normal, whether the transmission gears and inner and outer rollers are worn, whether the conveyor belt gap is appropriate, and whether the equipment grounding is reliable.

　　4. During operation, adjust the clamping stroke of the upper roller according to the diameter of the rolled angle steel flange; adjust the gap between the inner and outer rollers according to the thickness of the angle steel.

　　5. During operation, pay attention to prevent being crushed by the road roller.

　　6. Disconnect the main power supply when maintaining the equipment.

　　7. Regularly lubricate the bearings of the upper and lower rollers, as well as the slider and screw of the clamping device.

　　8. Unplug the power plug before leaving, put away the power cord, and clean the site.

　　The fully automatic duct production line manufacturer editor introduces it here. Thank you for watching, and see you next time.